H-2000-6040-0A-C Probe Systems Installation Manual for Machine Tools Renishaw plc New Mills, Wotton-under-Edge, Gloucestershire, GL12 8JR, United Kingdom National Tel: 01453 524524 Fax: 01453 524901 International Tel: +44 1453 524524 Fax: +44 1453 524901 Telex: 437120 RENMET G email:
[email protected] Internet: http://www.renishaw.com The copyright in this document is vested in Renishaw plc. The document must not be reproduced in whole or in part, or used for tendering or manufacturing purposes, except with the consent of Renishaw Metrology then only on the condition that this notice is included in any such reproduction. Information contained in this document is believed to be accurate at the time of publication but no liability whatsoever can be accepted by Renishaw plc arising out of any use made of this information. Unless otherwise expressly stated neither this document nor any information contained in it shall be deemed to constitute or form part of an invitation to treat or offer to contract for the product(s) described in this document. © 1996 Renishaw plc. All rights reserved. Renishaw® is a registered trademark of Renishaw plc. Manual No: H-2000-6040-0A-C First Issued Revised – – March 1996 June 1998 August 1998 The software you have purchased is used to control the movements of a machine tool. It has been designed to cause the machine to operate in a specified manner under operator control, and has been configured for a particular combination of machine tool hardware and controller. Renishaw have no control over the exact program configuration of the controller, with which the software is to be used, nor of the mechanical layout of the machine. Therefore, it is the responsibility of the person placing the software into operation to: • ensure that all machine safety guards are in position and are correctly working before commencement of operation; • ensure that any manual overrides are disabled before commencement of operation; • verify that the program steps invoked by this software are compatible with the controller for which they are intended; • ensure that any moves, which the machine will be instructed to make under program control, would not cause the machine to inflict damage upon itself or upon any machine in the vicinity; • be thoroughly familiar with the machine tool and its controller, and to know the location of all emergency stop switches. Form 1 Equipment Registration Record Please complete this form (and Form 2 overleaf if applicable) after the Renishaw equipment has been installed on your machine. Keep one copy yourself and return a copy to your local Renishaw Customer Support office (refer to the manual for the address and telephone number). The Renishaw Installing Engineer should normally complete these forms. MACHINE DETAILS Machine Description ..........................................................