Inspection Software For Lathes

Programming manual H-2000-6021-0C-C Inspection software for lathes (Fanuc 0/6/10-15/16/18/21T & iT) (Yasnac LX3) © 1998 – 2003 Renishaw plc. All rights reserved. Renishaw® is a registered trademark of Renishaw plc. This document may not be copied or reproduced in whole or in part, or transferred to any other media or language, by any means, without the prior written permission of Renishaw. The publication of material within this document does not imply freedom from the patent rights of Renishaw plc. Disclaimer Considerable effort has been made to ensure that the contents of this document are free from inaccuracies and omissions. However, Renishaw makes no warranties with respect to the contents of this document and specifically disclaims any implied warranties. Renishaw reserves the right to make changes to this document and to the product described herein without obligation to notify any person of such changes. Trademarks All brand names and product names used in this document are trade names, service marks, trademarks, or registered trademarks of their respective owners. Renishaw part no: H-2000-6021-0C-C First issued: Revised: January 1998 April 1998 January 1999 February 1999 July 2003 Form 1 EQUIPMENT REGISTRATION RECORD Please complete this form (and Form 2 overleaf if applicable) after the Renishaw equipment has been installed on your machine. Keep one copy yourself and return a copy to your local Renishaw Customer Support office (refer to the manual for the address and telephone number). The Renishaw Installation Engineer should normally complete these forms. MACHINE DETAILS Machine description..................................................................……………......................................................... Machine type........................................................………………......................................................................... Controller................................………………………............................................................................................. Special control options.............................................................................….......................................…............. ....................................................................................................................……………………………….............. ....................................................................................................................……………………………….............. RENISHAW HARDWARE RENISHAW SOFTWARE Inspection probe type ....................................... Inspection disk(s)......................................……............... Interface type ................................................... ..........................................................................…........... .............................................................................…........ Tool setting probe type ................................... Tool setting disk(s) ..............................................…...... Interface type ................................................... ..................................................................................…... ......................................................................................... SPECIAL SWITCHING M