E-Book Overview
This publication has been developed to help engineers analyze, design and detail low-rise cast-in-place conventionally reinforced concrete buildings in accordance with the 2009 edition of the International Building Code® (IBC®). The 2009 IBC references the 2008 edition of Building Code Requirements for Structural Concrete (ACI 318-08) and the 2005 edition of ASCE/SEI 7, Minimum Design Loads for Buildings and Other Structures, the narrative and examples are based on these current standards wherever applicable. Section numbers and equation numbers from the 2009 IBC®, ACI 318-08 and ASCE/SEI 7-05 that pertain to the specific requirements are provided throughout the text.
E-Book Content
Design of Low-Rise Reinforced Concrete Buildings Based on the 2009 IBC ®, ASCE/SEI 7-05, ACI 318-08
David A. Fanella, Ph.D., S.E., P.E., F.ASCE
Design of Low-Rise Reinforced Concrete Buildings Based on the 2009 IBC, ASCE/SEI 7-05, ACI 318-08
ISBN: 978-1-58001-797-8 Cover Design: Manager of Development: Project Editor: Publications Manager: Typesetting:
Duane Acoba John Henry Jodi Tahsler Mary Lou Luif Cheryl Smith
COPYRIGHT © 2009
Cover photo courtesy of Portland Cement Association. ALL RIGHTS RESERVED. This publication is a copyrighted work owned by the International Code Council, Inc. Without advance written permission from the copyright owner, no part of this book may be reproduced, distributed or transmitted in any form or by any means, including, without limitation, electronic, optical or mechanical means (by way of example, and not limitation, photocopying or recording by or in an information storage retrieval system). For information on permission to copy material exceeding fair use, please contact: Publications, 4051 West Flossmoor Road, Country Club Hills, IL 60478. Phone 1-888-ICC-SAFE (422-7233). The information contained in this document is believed to be accurate; however, it is being provided for informational purposes only and is intended for use only as a guide. Publication of this document by the ICC should not be construed as the ICC engaging in or rendering engineering, legal or other professional services. Use of the information contained in this workbook should not be considered by the user to be a substitute for the advice of a registered professional engineer, attorney or other professional. If such advice is required, it should be sought through the services of a registered professional engineer, licensed attorney or other professional. First Printing: September 2009
PRINTED IN THE U.S.A.
TABLE OF CONTENTS PREFACE ACKNOWLEDGMENTS CHAPTER 1 – INTRODUCTION ....................................................................... 1-1 1.1 OVERVIEW ............................................................................................... 1-1 1.2 SCOPE ...................................................................................................... 1-1 1.3 REFERENCES .......................................................................................... 1-4 CHAPTER 2 – FLOOR SYSTEMS .................................................................... 2-1 2.1 INTRODUCTION ....................................................................................... 2-1 2.2 GENERAL CONSIDERATIONS ................................................................ 2-1 2.3 FLOOR SYSTEMS .................................................................................... 2-2 2.3.1 Flat Plate System ............................................................................ 2-2 2.3.2 Flat Slab System ............................................................................. 2-6 2.3.3 Beam-Supported Slab System ........................................................ 2-8 2.3.4 One-Way Joist System ....................................................................