E-Book Overview
To investigate possible improvements to the design of isolated structures, an extensive research program was conducted. Analytical and experimental investigations are presented to characterize multistage spherical sliding isolation bearings capable of progressively exhibiting different hysteretic properties at different stages of response. A newly developed analytical model is implemented as part of a parametric study of single- and multistory buildings incorporating a wide class of isolation systems. Behavior of the new triple pendulum bearing is compared with that of linear isolation systems with both nonlinear viscous and bilinear hysteretic energy dissipation mechanisms. The results of parametric analyses are used to develop a design framework based on targeting a multi-objective Seismic Performance Classification (SPC). This SPC is introduced to describe satisfaction of a complex seismic performance objective, defined as aggregate damage state limitation over multiple levels of seismic hazard. The probability of satisfying specific SPCs is computed for three- and nine-story buildings on all classes of isolators investigated.
E-Book Content
PACIFIC EARTHQUAKE ENGINEERING RESEARCH CENTER The Use of Base Isolation Systems to Achieve Complex Seismic Performance Objectives Troy A. Morgan Center for Urban Earthquake Engineering Tokyo Institute of Technology Stephen A. Mahin Department of Civil and Environmental Engineering University of California, Berkeley PEER 2011/06 JULY 2011 Disclaimer The opinions, findings, and conclusions or recommendations expressed in this publication are those of the author(s) and do not necessarily reflect the views of the study sponsor(s) or the Pacific Earthquake Engineering Research Center. The Use of Base Isolation Systems to Achieve Complex Seismic Performance Objectives Troy A. Morgan Center for Urban Earthquake Engineering Tokyo Institute of Technology Stephen A. Mahin Department of Civil and Environmental Engineering University of California, Berkeley PEER Report 2011/06 Pacific Earthquake Engineering Research Center College of Engineering University of California, Berkeley July 2011 ii ABSTRACT One concern in the design of base isolated structures is the selection of isolation system properties so that optimal performance is achieved over a range of seismic levels and performance metrics. To withstand very rare ground motions, isolation bearings are frequently designed with significant strength or damping, and as a result such devices provide reduced isolation effect for more frequent seismic events. To investigate possible improvements to the design of isolated structures, an extensive research program is conducted. Analytical and experimental investigations are presented to characterize multistage spherical sliding isolation bearings capable of progressively exhibiting different hysteretic properties at different stages of response. Shaking table tests are conducted on a 1/4-scale seismically isolated steel braced frame on multi-stage bearings, including harmonic characterizations tests and earthquake simulations. These tests included various input intensities, multi-component excitation, bearing uplift, and superstructure response. A newly developed analytical model is implemented as part of a parametric study of single- and multistory buildings incorporating a wide class of isolation systems. Behavior of the new triple pendulum bearing is compared with that of linear isolation systems with both nonlinear viscous and bilinear hysteretic energy dissipation mechanisms. The results of parametric analyses are used to develop a design framework based on targeting a multi-objective Seismic Performance Classification (SPC). This SPC is introduced to describe satisfaction of a complex seismic performance objective, defi